The technique involves two methods, moving a light around in the frame during a long exposure, similar to writing with a sparkler, on cracker night, or using a controlled light source, such as a flashlight or speedlight, on or off camera, to light a particular part of a scene.
The latter is more of a contrived and creative technique that can yield spectacular results, especially in a commercial setting. LED torches are the tool of choice here. $6.95 from Kmart, will get you a small pocket sized, but extremely bright and useful LED torch, which is also daylight balanced, so you won’t get any undue yellow shift in colour to whatever you light up. I often use colored gels / filters that go with my Canon speedlight, over the light source to further increase the dynamic feel of the image. I used this technique on a trip earlier in the year to the tip of Cape York.
A major part of light painting involves setting your composition. Often hard to do, when you in the pitch of night, with all the necessary evils at hand. No moon, no ambient light, and quite often in the middle of a quiet nowhere, all alone. If you’re well prepared, you’ll find that the tiniest amount of light in such a setting will have either a dramatic or devastating effect in your shot, so paint carefully.
I always test the setting, with sample shots of various areas, to measure the reflectiveness off anything shiny or wet, the time absorbed when lighting dark corners and the relevant amount of exposure to suit each. From there, you’ll need to orchestrate, which parts of the scene, are to receive a “heavy brush” of light exposure with the torch or flash, and which are to receive a “sprinkle. And you thought it was an easy technique! Using a torch, will provide you with so much more control, as a speedlight flash will never “choose its target”
For this article, I thought I’d step you through how to create your own image using the light painting technique. Light painting does take a while to grasp as there are many places you can make minor mistakes which consequently ruin the shot, but with a little knowledge and advice, anyone can try this technique.??Equipment Required?- Digital Camera?- Tripod?- Light Source – Flash or Torch or anything else you can think of (I’ve used my iPhone before!!)?- An open mind!
OK, first, set your tripod up to a predetermined height and leave it to the side. Time to scout for a scene. There’s no point setting all your equipment up to find that you just have to move later because something is killing your shot or getting in the way. I take my camera and walk the scene, looking for interesting things watching my background is not too congested, and that I have a way of separating my subject from the “junk”.
Switch your camera to manual, and auto-focus or AF. Zoom in and find a light source or light area that is the same distance away as the subject you want in focus, press the shutter half way down. If need be artificially light the subject with your new LED torch. Once focused zoom back out to your desired length and make sure, without touching the shutter or the focus ring switch back to manual focus. Make sure you’re not touching the focus ring when you compose.
This is something that no tutorial can tell you how to do, this is in the eye of the photographer. Be creative and show off your creative eye.
QUICK TIP: Wide angles make for much more interesting settings at night than longer focal lengths.
Nearly there, but getting the exposure right, is crucial. The best way to expose your shot manually is to use your camera’s built in light meter as a rough guide, but not as a precise judge. When you first start you will need to follow it tightly but as you gain more and more experience you won’t need the meter at all.
Set the camera Mode to AV (Aperture priority) Now, set the ISO speed to 3200 (or your highest ISO available). As a rough guide I always start with an aperture anywhere in between f/4-f/8 to achieve maximum sharpness. Deeper apertures of f/16 etc will help your sharpness factor, but take much longer to expose, sometimes, too long. Two things you’ll need to be mindful of here, firstly, that such a shallow aperture setting of f/4 or f/8 will mean you will have to be accurate when focussing, and secondly, but just as important, the difference in exposure between these two apertures can greatly vary your result, depending on the conditions you’re in. Your in camera light meter will tell you its suggested exposure time when you half depress the shutter. Let’s just say the camera suggests a shutter speed of 10 seconds, remember 10 seconds. Now set the ISO to 100. Take your 10 seconds and multiply that number by 32. This gives us 320 seconds, Divide this by 60, this gives us about 5.5 minutes.
Now, drag out your light source and begin painting in sections of your scene, by shining your torch onto the scene, during each test exposure. Check the results with each test image you capture. Look to achieve a nice ambient overall exposure without too much digital noise (a drawback of long exposures on digital cameras) or excessive highlights. Using the results you measured in each of your test shots, you should now be able to see what parts of your scene require more light painting, and what parts only require a quick flash past.
Now plug in a remote shutter release, set the camera to BULB mode (move the shutter down past 30 seconds). Get a timing device (Phone, stop watch or similar) and get ready to wait. Press the remote shutter release and lock it on. Start the timer. Wait the desired time and check the results. Look for excessive highlights or shadows with no light (which will fill with digital noise), and adjust your torch technique to suit.
A few things to remember here, the longer your torch shines or the more times you flash your speedlight, the light will accumulate and therefore increase the overall exposure, hence why you should run test shots and paint carefully. It’s not an exact science to start with, but after a few test shots, your accuracy can be high, especially if you take notes, whether mental or written to help you orchestrate the final image. What do we call this?? Planning… the ideals of every good photographer should begin with good planning. In Light Painting, its essential.